Spray Can Straw Holder for 200ml and 400ml Cans

Design preview. Rendered from the file, not a photo.

The maker says it fits: spray cans (52.8mm, 57mm, 66mm diameter). See the proof

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

Clamps the straw to the can so you stop losing it
Sizes for 53mm, 57mm, and 66mm cans
Saves you the hunt for missing straws mid-project
Fits paint, lubricant, and air duster cans

Stop hunting for the straw every time you grab a spray can. This holder clamps the thin red straw right to the can, so it rides along and stays ready. Three sizes cover most paint cans, lubricants, and large 400ml air dusters.

Each size comes in a regular and a tight version, so you pick the grip that suits your printer settings. The holder slides over the can and stays put, even as the can empties and gets lighter.

A small part that fixes a daily annoyance. Buy one for the workshop, one for the garage, and one for the desk drawer.

5.1k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What it fits

The maker says it fits: spray cans (52.8mm, 57mm, 66mm diameter)

That is the maker's word, not a fit we measured. Check the size below against your own.

spray cans (52.8mm, 57mm, 66mm diameter)From the maker's own listing title, checked 2026-08-13. See the original post

What you get

This design prints as one piece.
Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.