Laundry Detergent Cup Drain Holder for Tide & Gain

Design preview. Rendered from the file, not a photo.

The maker says it fits: Tide and Gain 4.43L (1.17 US gal) laundry detergent containers. See the proof

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

Stores and drains detergent cups for Tide and Gain 4.43L containers
Designed to fit North American Proctor & Gamble brand bottles with 28mm drain opening
Single print-in-place design, no assembly required
Eliminates waste by funneling excess soap back into the bottle
Keeps your sink clean and mess-free during laundry prep

The Laundry Detergent Cup Drain Holder is a 3D-printed fixture designed to store and drain your detergent cup for Tide and Gain brand liquid laundry soap. Instead of rinsing the cup in the sink or letting excess detergent go to waste, this holder drains leftover soap directly back into the container, saving you money and reducing mess.

Compatible with North American Tide and Gain 4.43L containers (Proctor and Gamble brands) featuring a 28mm drain opening and 35mm outer thread diameter with 3mm pitch. The print-in-place design prints as a single assembled unit, ready to use out of the box.

If you use a different detergent brand, verify that your container's drain opening matches approximately 28mm. Note: Sunlight brand containers have smaller openings and will not fit this design.

15k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What it fits

The maker says it fits: Tide and Gain 4.43L (1.17 US gal) laundry detergent containers

That is the maker's word, not a fit we measured. Check the size below against your own.

Tide and Gain 4.43L (1.17 US gal) laundry detergent containers (model Gain 4)From the maker's own listing notes, checked 2026-08-13. See the original post

Brand names here only say what this part fits. We are not connected to those companies, and they did not make or check this part.

What you get

This design prints as one piece.
Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.