Laundry Soap Cup Holder: 3D Printed Home Decor

Design preview. Rendered from the file, not a photo.

The maker says it fits: Laundry detergent bottles with 1.7" spout. See the proof

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

Catches drips under your detergent spout so your laundry room floor stays clean and dry
Holds a cup around 2 inches wide, giving you a handy spot to measure soap without mess
Fits bottles with 1.7 inch spouts, so you can use it right away with your big jugs
Printed on demand just for you, so you get a fresh copy made to order

Your laundry room stays cleaner when detergent drips go into a cup instead of on the floor. This 3D-printed soap holder catches spills and holds your measuring cup in one simple piece.

The cup holder wraps around standard 1.7 inch bottle spouts and keeps a cup positioned underneath. When you pour, your soap goes where it should. No more sticky floors or wasted detergent running down the side of your jug.

You get this design printed fresh on demand, made in the USA. If your bottle spout runs a bit larger, let us know in the comments and we can adjust the fit for you.

7.3k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What it fits

The maker says it fits: Laundry detergent bottles with 1.7" spout

That is the maker's word, not a fit we measured. Check the size below against your own.

Laundry detergent bottles with 1.7" spout (model with 1)From the maker's own listing title, checked 2026-08-13. See the original post

Brand names here only say what this part fits. We are not connected to those companies, and they did not make or check this part.

What you get

This design prints as one piece.
Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.