Skip to content
3D Prints Fast

Pegboard Hooks for Ikea Skadis Mounted Sideways

Pegboard Hooks for Ikea Skadis Mounted Sideways, design preview, turn three quarter

Design preview. Rendered from the file, not a photo.

The maker says it fits: Ikea Skadis pegboard. See the proof

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

  • Hooks fit a Skadis pegboard mounted at 90 degrees
  • Lets you slide hooks left and right on the board
  • Side-printed versions fit a standard pegboard too
  • Frees up wall space for tool storage
  • Holds a tidy line of hand tools

Get more from your Skadis pegboard. If you mounted the board sideways, the stock hooks do not slide. These hooks are built for that 90-degree layout, so you can slide them left and right to find the right spot for each tool.

The side-printed versions also fit a standard pegboard, with the pegs about 40mm apart. A handy starter set for any wall-mounted tool kit.

Made in the USA.

4.0k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What it fits

The maker says it fits: Ikea Skadis pegboard

That is the maker's word, not a fit we measured. Check the size below against your own.

Brand names here only say what this part fits. We are not connected to those companies, and they did not make or check this part.

Part of the Skadis pegboard accessories system.

These are community-designed accessories that fit the IKEA SKADIS pegboard. They are not made by IKEA, and we are not affiliated with IKEA. Explore the system

What you get

  • This design prints as one piece.
  • Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.

More like this

Who made this design

Designed by Ovious. We did not draw it.

Shared under Creative Commons, credit required. See the original design