Laundry Cap Drip Shelf for Closetmaid Wire Shelves

Design preview. Rendered from the file, not a photo.

The maker says it fits: Closetmaid wire shelf. See the proof

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

Clips onto your wire shelf so laundry caps sit right under the spout, keeping drips off your floor
Holds the cap steady during dispensing so you can pour without worrying about mess or cleanup
Made with sturdy walls, 4 mm thick, so it handles daily use without cracking or bending
Printed on demand from the US, custom-made just for your shelf setup

Stop drips before they hit your floor. This little shelf clips right onto your Closetmaid wire shelf and holds your laundry cap directly under the dispenser spout, so every drop goes where it belongs.

You get a simple, sturdy design that does one job well. The shelf features thick walls, about 4 mm, built to last through years of refills. Just clip it on, slide your cap underneath, and dispense. No mess, no puddles, no extra cleaning time.

Printed to order from the US, this shelf is made to fit your exact setup. It works with standard Closetmaid wire shelving and holds caps securely in place while you pour.

1.7k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What it fits

The maker says it fits: Closetmaid wire shelf

That is the maker's word, not a fit we measured. Check the size below against your own.

Closetmaid wire shelfFrom the maker's own listing notes, checked 2026-08-13. See the original post

Brand names here only say what this part fits. We are not connected to those companies, and they did not make or check this part.

What you get

This design prints as one piece.
Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.