Citadel Paint Pegboard Holder, 3D Printed Organizer

Design preview. Rendered from the file, not a photo.

The maker says it fits: Standard home depot pegboard. See the proof

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

Holds up to 4 paint pots so your collection stays organized on the wall
Snug pegboard fit keeps the tray secure and steady when you add or remove pots
Designed for standard pegboards, so it works with hardware store pegs right away
Minimal support needed during printing, which saves time and material costs

Keep your Citadel paints where you can see them. This pegboard holder clips onto any standard pegboard and holds your paint pots upright and ready to use. No more hunting through drawers or boxes for the color you need.

The holder grips your pegboard tight so it will not wiggle or slip when you reach for pots. The design fits pegs spaced 1 inch apart with 1/4 inch holes, matching pegboards from any home improvement store. It holds 4 pots at a time and prints with just 2 support points, keeping print time and waste low.

You get the file to print on demand. Install with care, making sure the pegs go straight into the board without twisting. Once seated, your holder stays put and looks clean on your wall.

4.4k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What it fits

The maker says it fits: Standard home depot pegboard

That is the maker's word, not a fit we measured. Check the size below against your own.

Standard home depot pegboardFrom the maker's own listing notes, checked 2026-08-13. See the original post

Brand names here only say what this part fits. We are not connected to those companies, and they did not make or check this part.

What you get

This design prints as one piece.
Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PETG. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.