Caliper Holder for Workshop Tools, Fits IKEA Skadis

Design preview. Rendered from the file, not a photo.

The maker says it fits: Ikea Skadis pegboard (32mm spacing). See the proof

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

Mounts calipers to your Ikea Skadis pegboard so they stay organized and easy to grab
Takes up minimal space on the board, so you can fit more tools in your workshop
Holds calipers steady and secure, so measurements stay accurate when you need them
Made to fit standard Skadis pegs, so installation takes just seconds

Your pegboard stays packed with the tools you use most. This caliper holder clips right onto your Ikea Skadis board and keeps calipers within arm's reach, taking up just inches of space.

The holder grips your calipers tight so they do not slip or wobble. The compact design lets you stack more holders on one board, so your entire workshop stays organized. Print it upside down on your printer bed for the best result.

11k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What it fits

The maker says it fits: Ikea Skadis pegboard (32mm spacing)

That is the maker's word, not a fit we measured. Check the size below against your own.

Ikea Skadis pegboard (32mm spacing) (model 32mm)From the maker's own listing title, checked 2026-08-13. See the original post

Brand names here only say what this part fits. We are not connected to those companies, and they did not make or check this part.

Part of the Skadis pegboard accessories system.

These are community-designed accessories that fit the IKEA SKADIS pegboard. They are not made by IKEA, and we are not affiliated with IKEA. Explore the system

What you get

This design prints as one piece.
Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.