3D Printed SD Card Case Organizer Replacement

Design preview. Rendered from the file, not a photo.

The maker says it fits: SD Card. See the proof

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

Clips your SD card board in safely so it stays protected inside your laptop
One-piece design slides together fast, so you spend less time fussing with broken cases
Secure with tape or glue for peace of mind so your card never gets lost
Fix your broken SD card holder without buying a new one, saving you money

Your SD card deserves better than a broken case. This replacement holds your card board snug in a single clip slot, so the tiny electronics stay safe and sound inside your device. No more worrying about loose parts falling out when you move your card around.

The design is simple and smart. Your SD card slides into the slot and clips tight. You can lock it down with a small piece of tape or super-glue to make sure nothing moves during use. Made right here and printed fresh for you on demand.

Whether your old case split apart or the bridges cracked off, this replacement gets your card working again without the hassle. Print it, clip it, and protect what matters.

3.9k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What it fits

The maker says it fits: SD Card

That is the maker's word, not a fit we measured. Check the size below against your own.

SD CardFrom the maker's own listing title, checked 2026-08-13. See the original post

Brand names here only say what this part fits. We are not connected to those companies, and they did not make or check this part.

What you get

This design prints as one piece.
Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.