3D Printed Hex Bit Holder for Ikea Skadis

Design preview. Rendered from the file, not a photo.

The maker says it fits: Ikea Skadis pegboard. See the proof

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

Mounts flat to your Skadis pegboard so you keep bits organized and within arm's reach.
Low profile design holds hex bits securely, so your drill bits stay sorted and ready to use.
Printed on demand from the US, made just for your workshop setup.
Works with standard Skadis pegs, so you expand your pegboard without buying expensive add-ons.

Your workshop stays tidy when your hex bits have their own home. This 3D-printed holder clips right onto your Ikea Skadis pegboard, keeping bits visible and easy to grab.

The holder sits low and flat against the board, so it does not stick out or get in your way. Just print it with the flat side down, attach it to your Skadis pegs, and load your bits. You get a clean, custom setup that costs way less than store-bought organizers.

Perfect for anyone who uses the same few bits over and over. No more digging through drawers or boxes. Your bits stay right where you can see them.

2.5k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What it fits

The maker says it fits: Ikea Skadis pegboard

That is the maker's word, not a fit we measured. Check the size below against your own.

Ikea Skadis pegboardFrom the maker's own listing notes, checked 2026-08-13. See the original post

Brand names here only say what this part fits. We are not connected to those companies, and they did not make or check this part.

Part of the Skadis pegboard accessories system.

These are community-designed accessories that fit the IKEA SKADIS pegboard. They are not made by IKEA, and we are not affiliated with IKEA. Explore the system

What you get

This design prints as one piece.
Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.