VW Remote Clamp Fix - 3D Printed Car Accessories

Design preview. Rendered from the file, not a photo.

The maker says it fits: Volkswagen car key remote. See the proof

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

Holds broken remote halves together without glue, so you can still swap the battery when you need to.
Saves you money by fixing a cracked remote instead of buying a replacement.
Requires only one small drill notch on your key remote, so the repair stays simple and non-invasive.
Prints easily on most 3D printers, so you get a working fix fast.

Your Volkswagen remote cracked when it hit the floor. A replacement costs a lot of money. This 3D-printed clamp gives you a better way: fix it yourself and keep using it for years to come.

The clamp works like a spring lever that holds both halves of your remote together. You drill one small notch into the metal key side of the remote, then snap the clamp in place. No glue needed, which means you can still open it up to replace the battery whenever you want.

This design shows what 3D printing can do: it turns a broken item into a working one again. Get your file printed on demand and fix your remote today.

1.3k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What it fits

The maker says it fits: Volkswagen car key remote

That is the maker's word, not a fit we measured. Check the size below against your own.

Volkswagen car key remoteFrom the maker's own listing title, checked 2026-08-13. See the original post

Brand names here only say what this part fits. We are not connected to those companies, and they did not make or check this part.

What you get

This design prints as one piece.
Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.