Thermometer Hygrometer Stand, 3D Printed Office Accessory

Design preview. Rendered from the file, not a photo.

The maker says it fits: standard thermometer/hygrometer units ~48x28.5x15.2mm with snap-fit clamp. See the proof

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

Holds two thermometers and hygrometers steady so you can read them from your desk without bending
Snap-in clamp design means no glue or screws needed, so setup takes under a minute
Sized for standard 48 x 28.5 x 15.2mm devices, so your gauges fit snug and secure
Keeps your desk organized and clean so you can monitor temperature and humidity at a glance
Designed for indoor use on desks, shelves, and workspaces

Keep your thermometers and hygrometers where you can see them. This stand holds two monitors upright on your desk so you always know the temperature and humidity in your space without cluttering your work area.

The holder uses a simple snap-in clamp design that grips your devices tight. No screws. No glue. Just drop your thermometer in and you are done. The stand is built for devices around 48 x 28.5 x 15.2mm, which fits most standard electronic thermometers and hygrometers you buy from electronics stores.

Your desk stays neat and your readings stay visible. This 3D-printed stand gives you a clean way to track your indoor climate right where you work.

2.1k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What it fits

The maker says it fits: standard thermometer/hygrometer units ~48x28.5x15.2mm with snap-fit clamp

That is the maker's word, not a fit we measured. Check the size below against your own.

standard thermometer/hygrometer units ~48x28.5x15.2mm with snap-fit clamp (model 48x28)From the maker's own listing title, checked 2026-08-13. See the original post

What you get

This design prints as one piece.
Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.