Skip to content
3D Prints Fast

Pegboard Screwdriver Holder for 8 Drivers

Pegboard Screwdriver Holder for 8 Drivers, design preview, hero tilt

Design preview. Rendered from the file, not a photo.

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

  • Holds eight screwdrivers upright on a pegboard
  • Two side rows stop drivers from tilting sideways
  • Frees up drawer space and speeds tool selection
  • Print fast with the slim back design
  • A clean shop upgrade for daily driver organization

You glance at the pegboard and the screwdrivers stand at attention in two neat rows. The dual support stops the lean that ruins most upright tool holders, so the drivers stay where you put them.

The remixed back uses less material and prints faster than the original, so a full set of drivers gets organized in one print run. Add as many holders as you need to fit the wall.

Use it for Phillips, flathead, and precision drivers in any home shop. A piece that earns its space the first time you reach for the right size.

5.5k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What you get

  • This design prints as one piece.
  • Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.

More like this

Who made this design

Designed by carlol. We did not draw it.

Shared under Creative Commons, credit required. See the original design