LED Panel Clip: 3D Printed Organizers for Light Strips

Design preview. Rendered from the file, not a photo.

The maker says it fits: 15x6mm aluminum LED profiles. See the proof

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

Holds aluminum profiles steady so your LED strips stay aligned and skip the messy rewiring.
Fits 15x6mm profiles with 10mm LED strips, so you get a clean setup that matches your exact setup.
Clips onto your panel with UV-curable glue, so your lights stay put without drilling or tools.
Print on demand means you only make what you need, cutting down on waste and shipping costs.
Customizable scale lets you dial in the fit for your printer, so nothing goes to waste.

Your LED strip setup stays neat and organized when each light is clipped in place. No more sagging profiles or tangled wires behind your monitor or shelf. These clips hold everything tight so you can focus on the glow, not the mess.

The clip wraps around 15x6mm aluminum profiles and grips 10mm LED strips with an 8mm gap between them. You print it at 102% scale, then glue it with UV-fast curable adhesive to lock it down. The design comes from the community at Thingiverse, tested and refined by makers just like you.

Print these on demand means zero waste and zero storage hassle. Make one clip or ten. Scale them up or down to match your exact panel size. This is how smart lighting gets built.

What it fits

The maker says it fits: 15x6mm aluminum LED profiles

That is the maker's word, not a fit we measured. Check the size below against your own.

15x6mm aluminum LED profiles (model 15x6mm)From the maker's own listing notes, checked 2026-08-13. See the original post

Brand names here only say what this part fits. We are not connected to those companies, and they did not make or check this part.

What you get

This design prints as one piece.
Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.