Iwata Eclipse Airbrush Wall Mount with Drip Trays

Design preview. Rendered from the file, not a photo.

The maker says it fits: Anest Iwata Eclipse HP-CS (and compatible airbrushes). See the proof

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

Holds your airbrush on the wall so it stays within arm's reach and saves bench space
Built-in drip trays catch overspray, so your workspace stays clean while you work
Anti-tilt nub keeps your brush steady, so you can hang it and grab it when ready
Hose slot lets you connect to your compressor while mounted, so setup takes seconds

Your airbrush deserves a home that keeps it safe and ready to use. This wall mount holds your Iwata Eclipse brush at the perfect angle with drip trays built right in.

The holder fits snugly around your Eclipse gravity-feed airbrush. The anti-tilt nub stops it from rolling. You can thread your hose through the slot, so the brush hangs connected and ready. Overspray drips into the integrated trays instead of onto your floor.

Made in the USA from 3D-printed materials. Works best with the Iwata Eclipse HP-CS; may fit other airbrush models depending on size and shape.

3.4k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What it fits

The maker says it fits: Anest Iwata Eclipse HP-CS (and compatible airbrushes)

That is the maker's word, not a fit we measured. Check the size below against your own.

Anest Iwata Eclipse HP-CS (and compatible airbrushes)From the maker's own listing notes, checked 2026-08-13. See the original post

Brand names here only say what this part fits. We are not connected to those companies, and they did not make or check this part.

What you get

This design prints as one piece.
Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.