Golf-Clamp 3D Printed Phone Holder for VW Air Vents

Design preview. Rendered from the file, not a photo.

The maker says it fits: Volkswagen Golf 6 (2008-2012). See the proof

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

Grips your phone or satnav in your dashboard air vent so your hands stay on the wheel while driving.
Bends slightly to fit snug, then locks firmly in place without screws or glue; no tools needed.
Fits Golf 6 models from 2008 to 2012, and works with other VW vehicles like Eos.
3D printed on demand just for you, so you get a fresh custom part made to order.
Holds devices steady at eye level so you can check directions or take calls hands-free.

Your phone stays put where you need it. This vent clamp holds your device steady at dashboard level so you can see your satnav and keep both hands on the steering wheel.

The Golf-Clamp is designed to grip your phone or satnav right into your air discharge vent. It bends slightly during install, then stays locked in position without any screws, glue, or fasteners. The simple design works for Golf 6 cars made from 2008 to 2012, and fits other VW models like the Eos.

Your clamp arrives 3D printed and ready to use. Just install it into your vent, flex it slightly until it seats tight, and you are done. No drilling, no mess, no fuss.

1.2k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What it fits

The maker says it fits: Volkswagen Golf 6 (2008-2012)

That is the maker's word, not a fit we measured. Check the size below against your own.

Volkswagen Golf 6 (2008-2012) (model Golf 6)From the maker's own listing notes, checked 2026-08-13. See the original post

Brand names here only say what this part fits. We are not connected to those companies, and they did not make or check this part.

What you get

This design prints as one piece.
Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.