Elegant Arch MacBook Pro Stand for 17" 2011 Unibody

Design preview. Rendered from the file, not a photo.

The maker says it fits: MacBook Pro (17" 2011 unibody, 26mm slot width). See the proof

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

A vertical arch shape, so your laptop stands upright on your desk
A 26mm wide slot sized for the 2011 unibody 17" MacBook Pro
Open arch design leaves room around the MagSafe cable and vents
Made to order in the USA after you order
Frees up desk space so you can spread out your work

Desk workers who want their laptop off the flat surface can set it upright in this arch stand. The curved shape lifts your MacBook Pro so you can see your desk space instead of a flat laptop lid.

The stand is shaped for the 17" 2011 unibody MacBook Pro, with a 26mm wide slot cut for the body of that specific model. The open arch leaves clearance around the edges and back, so the vents and the 2011 MagSafe cable have room to sit without being boxed in.

This is a single stand, one arch shape, made for the one laptop model it names. It is made to order in the USA after you place your order.

27k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What it fits

The maker says it fits: MacBook Pro (17" 2011 unibody, 26mm slot width)

That is the maker's word, not a fit we measured. Check the size below against your own.

MacBook Pro (17" 2011 unibody, 26mm slot width)From the maker's own listing title, checked 2026-08-13. See the original post

Brand names here only say what this part fits. We are not connected to those companies, and they did not make or check this part.

What you get

This design prints as one piece.
Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.