DIN Rail Cable Clamp with Zip Tie Slots

Design preview. Rendered from the file, not a photo.

The maker says it fits: 35mm DIN rail. See the proof

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

Clips onto a standard 35 mm DIN rail
Slots for cable ties to secure power and signal cables
Saves you from running cables on bare desks or benches
Releases with a fingernail or screwdriver
A clean upgrade for electronics workbenches

You set up the DIN rail on the bench and every cable runs in tidy zip-tied lines. This clamp clips onto a standard 35 mm DIN rail (the kind used for industrial enclosures and electronics workbenches), with zip tie slots that hold cables firm.

The release works the same way as standard DIN clips: slide a fingernail or a screwdriver into the bottom slot to pop the clamp off when you reorganize. Use it for power cords, signal cables, and any wire that needs to ride along a workbench rail.

A clean upgrade for any electronics or maker workbench.

8.8k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What it fits

The maker says it fits: 35mm DIN rail

That is the maker's word, not a fit we measured. Check the size below against your own.

35mm DIN rail (model 35mm)From the maker's own listing notes, checked 2026-08-13. See the original post

What you get

This design prints as one piece.
Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.