Desk Mount for Extension Cord, 28mm

Design preview. Rendered from the file, not a photo.

The maker says it fits: IKEA Idasen desk (28mm). See the proof

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

Clamps to your desk edge with no screws or glue, so you keep your workspace clean and damage-free
Holds extension cords steady and tucked away, so your cables stay organized and out of your way
Made for 28mm desks like the IKEA Idasen, so it fits your existing setup right away
Custom sizes available; just ask in the comments if you need a different desk width

Stop wrestling with tangled cords on your desk. This 3D-printed mount grips your extension cord tight and keeps it exactly where you need it, off your work surface and out of sight.

The mount slides onto desks that are 28mm wide, like the IKEA Idasen. No drilling holes. No permanent damage. Just snap it on and go. Your cables stay put while you focus on work.

Need a different size. Let us know in the comments and we can adjust the design for your desk width before we print it for you.

1.9k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What it fits

The maker says it fits: IKEA Idasen desk (28mm)

That is the maker's word, not a fit we measured. Check the size below against your own.

IKEA Idasen desk (28mm) (model 28mm)From the maker's own listing notes, checked 2026-08-13. See the original post

What you get

This design prints as one piece.
Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.