Compatible with Milwaukee Packout Vacuum Feet Set

Design preview. Rendered from the file, not a photo.

The maker says it fits: Milwaukee M18 Packout 18V Vacuum 0880-20 (old model). See the proof

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

Replacement feet for the older 0880-20 Packout vacuum
Fixes the scaling issue from earlier remixes
Lets your vacuum stack cleanly on Packout cases
Saves you from buying a whole new tool
3D-printed and made in the USA

Get your old Packout vacuum stacking again. These replacement left and right feet fit the old style 0880-20 wet/dry vacuum and bring it back into the Packout family. You snap them on, and your vacuum locks into the rest of the system.

This version corrects the scaling issue that earlier remixes had, so the fit is true. The feet hold up to job site use and stack rigid under load. You stop tripping over a vacuum that no longer fits your kit.

Made in the USA. A clean fix for owners of the older Milwaukee Packout vacuum.

Not affiliated with, endorsed by, or sponsored by Milwaukee. Milwaukee and its product names are trademarks of their respective owners.

890 downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What it fits

The maker says it fits: Milwaukee M18 Packout 18V Vacuum 0880-20 (old model)

That is the maker's word, not a fit we measured. Check the size below against your own.

Milwaukee M18 Packout 18V Vacuum 0880-20 (old model) (model M18)From the maker's own listing title, checked 2026-08-13. See the original post

Brand names here only say what this part fits. We are not connected to those companies, and they did not make or check this part.

What you get

This design has 2 separate printed pieces.
Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.