Compatible with Einhell TP-CD/TE-CD Bit Holder (5-Slot, 3D Printed)

Design preview. Rendered from the file, not a photo.

The maker says it fits: TP-CD 18/80, TE-CD 18/40, TE-CD 18/50 and 1 more. See the proof

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

Holds 5 hex bits right on your drill handle for instant bit swaps
Sculpted to fit Einhell TP-CD, TE-CD, Ozito PXC, Parkside Performance drills
Flush with battery, won't snag on clothes or get in your way
Easy access: slide bits out with your fingernail, no fumbling
Includes wider-hole variant if your bits fit tight at first

Keep your bits exactly where you need them. This 3D printed bit holder clips onto the handle of your Einhell Power X-Change drill (and several others from the same factory) so you've got five hex bits ready to grab mid-project. The front slot is angled so you can pull a bit without bumping your hand, and the whole thing sits flush with the battery pack to avoid snagging.

It's sculpted to match the contours of Einhell TP-CD 18/50, TP-CD 18/80, TE-CD 18/40, TE-CD 18/50, TE-CD 18/2, and TE-CD 18/44 models, plus compatible Ozito PXC 18V, Parkside Performance PASSP/PABSP/PSBSAP 20V, and Bauer drills. The design is mirrored, so you can mount it on either side of your drill.

The hex slots may feel snug at first, that's intentional, but they'll break in after a few uses. If they're still too tight, just print the included wider-hole variant with 0.2 mm extra clearance.

Not affiliated with, endorsed by, or sponsored by Einhell. Einhell and its product names are trademarks of their respective owners.

3.2k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What it fits

The maker says it fits: TP-CD 18/80, TE-CD 18/40, TE-CD 18/50, TE-CD 18/2

That is the maker's word, not a fit we measured. Check the size below against your own.

TP-CD 18/80 (model CD 18)From the maker's own listing notes, checked 2026-08-13. See the original post
TE-CD 18/40 (model CD 18)From the maker's own listing notes, checked 2026-08-13. See the original post
TE-CD 18/50 (model CD 18)From the maker's own listing notes, checked 2026-08-13. See the original post
TE-CD 18/2 (model CD 18)From the maker's own listing notes, checked 2026-08-13. See the original post

What you get

This design prints as one piece.
Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.