Skip to content
3D Prints Fast

Cable Organizer Clip with Zip Tie Channels

Cable Organizer Clip with Zip Tie Channels, design preview, hero tilt

Design preview. Rendered from the file, not a photo.

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

  • Routes power and data cables along a desk or rig
  • Two channels for zip ties so the clip stays put
  • No more peeling double-sided tape every six months
  • A clean cable run for sim rigs, desks, and printer setups
  • Print a strip and your loose cables are gone

You glance under the desk and a tangle of cables stares back. These clips end that. Each one routes a couple of cables along a frame or a desk leg, with two channels for zip ties so the clip stays where you put it.

The zip tie channels are the upgrade that matters. Tape lifts after a few months, especially in warm rooms. Zip ties keep the clip in place for years, even on a sim racing chassis or a printer frame that vibrates.

Print a small strip of clips, mount them along the frame, and the cable run looks like a pro setup did it.

5.9k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What you get

  • This design prints as one piece.
  • Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.

More like this

Who made this design

Designed by jabolfan. We did not draw it.

Shared under Creative Commons, credit required. See the original design