Cable Clip Organizer, Simple Cable Holder Set
Design preview. Rendered from the file, not a photo.
This model is not currently offered as a verified ready to buy print.
What it does
- Simple clips that hold any cable type
- Five-minute print for each clip
- Just three grams of filament per piece
- Tidies cables on a desk, wall, or under a counter
- Stops the loose cable mess at home
Tame the cable mess at home or on your desk. These small clips snap onto any cable, then bolt or stick to a desk edge, a wall, or a counter side. The cable stays in place, off the floor, and out of the way.
Each clip prints in five minutes and uses three grams of filament, so you can run a stack of them in one bed. A simple fix for a problem in every room.
Made in the USA.
12k downloads in the maker community. That is interest in the design on the site it came from, not our sales.
What you get
- This design prints as one piece.
- Nothing else to print or buy for this to work.
What it is made of
Designs like this print well in PLA. Compare the materials.
Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.
More like this
Stackable USB Cable Holder, 3D Printed Office Organizer
Design library
Cable Spool - 3D Printed Office Accessories for Cord Management
Design library
Compatible with iPhone Lightning Cable Holder for Desk
Design library
USB Cable Holder, 3D Printed Office Accessory
Design library
Cable Savers Compatible with Apple Lightning Cables
Design library
RJ45 Ethernet Cable Clip Replacement
Design library
Cable Organizer for Desk, Sleek Wire Management Clip
Design library
3D Printed Cable Organizer, Wire Management Holder
Design library
Who made this design
Designed by denfi228_3Dprints. We did not draw it.
Shared under Creative Commons, credit and share alike. See the original design