Skip to content
3D Prints Fast

Cable Clamp for 6mm Wire Bundles

Cable Clamp for 6mm Wire Bundles, design preview, hero tilt

Design preview. Rendered from the file, not a photo.

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

  • Holds 6 mm cables along a wall, desk, or frame
  • Half-clamp version handles inside corner runs
  • Stops loose cables from sliding behind furniture
  • Mounts with screws, glue, or strong tape
  • Print a strip and your loose cables disappear

You glance at the wall and the cable runs in a clean line, hugging the corner the way it should. These clamps hold standard 6 mm cables, with a special half-clamp that turns inside corners cleanly.

The fit is firm enough that the cable does not jiggle, but easy to install with a press. Mount with screws, double-sided foam tape, or hot glue depending on the surface.

Use them for power cables, USB runs, monitor cords, and printer cables. A small piece that turns a messy run into a tidy one.

6.1k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What you get

  • This design has 2 separate printed pieces.
  • Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.

More like this

Who made this design

Designed by Topsee. We did not draw it.

Shared under Creative Commons, credit required. See the original design