Ribbed Glue Stick for Hot Glue Guns

Design preview. Rendered from the file, not a photo.

The maker says it fits: standard 10mm hot glue gun. See the proof

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

Ribbed surface, shaped for standard hot glue guns
Made to fit a standard hot glue gun feed path
Ribs run the length of the stick for a grip texture
Printed in PLA and made to order in the USA
A practical way to use up small bits of leftover material

Ribbed Glue Sticks give you a fresh way to keep your glue gun loaded. The ribs run along the stick from end to end, giving the surface texture the whole way down.

This stick is shaped to fit a standard hot glue gun. You drop it into your glue gun feed just like a normal stick and get back to your project.

It works well for workshop repairs, craft projects, or any job where you reach for the glue gun. Each one is printed in PLA and made to order in the USA after you place your order.

2.7k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What it fits

The maker says it fits: standard 10mm hot glue gun

That is the maker's word, not a fit we measured. Check the size below against your own.

standard 10mm hot glue gun (model 10mm)From the maker's own listing title, checked 2026-08-13. See the original post

What you get

This design prints as one piece.
Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.