Skip to content
3D Prints Fast

Cable Clamp CableClipV2 for Cable Management

Cable Clamp CableClipV2 for Cable Management, design preview, hero tilt

Design preview. Rendered from the file, not a photo.

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

  • Open cable inlet shape, so a cable can rest inside the loop
  • Made to order in the USA after you order
  • Loop shaped to fit a single measured cable diameter
  • A compact clip shape for a desk, wall, or under a table edge
  • Printed in PLA for a lightweight cable holder

On a desk with cables running everywhere, this clip gives each cord a loop of its own. The CableClipV2 is a small clamp shaped to hold one cable along a curved channel, so you can start sorting the mess behind your monitor or under your desk.

The loop shape is sized around a single cable diameter, with an inlet angle that opens toward the front. You can mount it near an outlet, along a desk edge, or behind a media stand to route a power cord or charging cable out of the way.

It is printed in PLA and made to order in the USA after you place your order. This listing is for one CableClipV2 clip in one fixed size.

1.1k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What you get

  • This design prints as one piece.
  • Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.

More like this

Who made this design

Designed by Inhumierer. We did not draw it.

Shared under GNU GPL. See the original design