Skip to content
3D Prints Fast

3D Printed BMW E39 Short Shift Knob

3D Printed BMW E39 Short Shift Knob, design preview, hero tilt

Design preview. Rendered from the file, not a photo.

The maker says it fits: BMW E39. See the proof

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

  • Sits 2.5 cm lower than factory knob so your hand reaches the gear shift faster and easier
  • Knurled grip surface keeps your hand from slipping when you shift, even when your hands are wet or sweaty
  • Custom noses snap onto your original mount so you get a secure fit without extra parts or tools

You want a shift knob that feels better in your hand and sits where you need it. This 3D printed shift knob for your E39 drops lower than the stock knob, so shifting feels quicker and more natural. The knurled surface grips your palm every time, giving you control when you move through the gears.

The design started from the Mishimoto short shifter concept but is built specifically for your car. Inside, little noses hold onto your original shift stick mount. Depending on your print settings, you may want to wrap the stick in a bit of tape first for the tightest fit. The M badge comes off easily if you want a cleaner look.

Print it upside down to use less support material and save time. You get a custom part made to order, so your knob arrives ready to bolt on and drive.

1.4k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What it fits

The maker says it fits: BMW E39

That is the maker's word, not a fit we measured. Check the size below against your own.

Brand names here only say what this part fits. We are not connected to those companies, and they did not make or check this part.

What you get

  • This design prints as one piece.
  • Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.

More like this

Who made this design

Designed by eddiegame. We did not draw it.

Shared under GNU GPL. See the original design