Get a box made to your exact measurements
A small circuit board, a battery, or a project that needs a home. Tell us the inside length, width, and height, and any holes you need, and we plan a box to fit.
Set your sizes
The enclosure builder is not live yet. Send us your numbers and a person plans the part with you.
What we can make
A box for a small electronics project
Set the inside length, width, and height around what goes in it.
A lid that snaps onto a project box
Choose a snap fit, a screw down lid, or a slide on lid.
How it works
- 1Tell us the sizes listed above.
- 2Send your numbers to the Solution Counter.
- 3A person looks at what you sent and plans the part.
- 4You see a price before anything is printed.
What we need from you
- The inside length, width, and height you need
- The lid style: snap fit, screw down, or slide
- Any mounting holes or vent slots, with count and size
Materials
Most project boxes use PLA. A box that sits outside or gets warm can use PETG instead.
See the full materials pageMeasurements and fit
- Measure the length, width, and height of what needs to fit inside.
- Add a little room around anything that needs to move or plug in.
- We make it to the sizes you give us.
Common questions
- Can the box have vent slots?
- Yes. Tell us how many and where, and we plan them into the walls.
- What lid styles are there?
- Snap fit, screw down, or a slide on lid. Tell us which one fits how often you need to open it.
- Will the box be sealed against water?
- A tight seal is not something we can promise on any printed part. Tell us if that matters and we will be honest about what a print can and cannot do.
Related solutions
Have a file? Upload it.
Paste the model page
Need help? Ask the Solution Counter.