Skip to content
3D Prints Fast

Solar Panel Housing for 60x110mm Panels

Solar Panel Housing for 60x110mm Panels, design preview, hero tilt

Design preview. Rendered from the file, not a photo.

The maker says it fits: 60x110mm solar panel. See the proof

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

  • Holds your solar panel steady at any angle so you can aim it straight at the sun
  • Three fixing holes on each side let you mount it however works best for your setup
  • Lightweight design keeps your solar project easy to move and adjust
  • Fits standard 60x110mm solar panels from common suppliers

Keep your solar panel safe and pointed the right way. This housing holds your panel firm so it catches more sun and works harder for you.

The design is simple and light. Three holes run along every side, so you can fix the housing at any angle you need. Those same holes hold your 60x110mm solar panel inside. Want to tilt it toward morning sun? Turn it afternoon? You can adjust it anytime.

Build one for a garden light, a small charger, or any solar project. The sturdy design protects your panel while you stay in full control of where it points.

1.5k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What it fits

The maker says it fits: 60x110mm solar panel

That is the maker's word, not a fit we measured. Check the size below against your own.

  • 60x110mm solar panel (model 60x110mm)From the maker's own listing title, checked 2026-08-13. See the original post

Brand names here only say what this part fits. We are not connected to those companies, and they did not make or check this part.

What you get

  • This design prints as one piece.
  • Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.

More like this

Who made this design

Designed by mechanicsnail. We did not draw it.

Shared under BSD. See the original design