No Tangle Flag Collar Kit, 3D Printed Outdoor Gear

Design preview. Rendered from the file, not a photo.

The maker says it fits: 19mm diameter flag pole. See the proof

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

Stops your flag from tangling around the pole so it flies freely every time
Clips onto any standard flag pole, no tools or complicated setup needed
Keeps your flag neat and ready to display, saving you frustration on windy days
3D-printed design you get custom made for your needs

Your flag stays unfurled and proud, without twisting around the pole. This simple collar kit solves the annoying problem of flags tangling and bunching up, so your flag always looks sharp.

The No Tangle Flag Collar works on standard flag poles. It holds your flag in place so wind and motion don't wrap it around itself. Just clip it on and you're done. No special tools, no fuss.

Made in the USA and 3D-printed to order, this gear is built to handle outdoor weather and keep your flag flying right.

1.8k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What it fits

The maker says it fits: 19mm diameter flag pole

That is the maker's word, not a fit we measured. Check the size below against your own.

19mm diameter flag pole (model 19mm)From the maker's own listing title, checked 2026-08-13. See the original post

What you get

This design prints as one piece.
Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.