Skip to content
3D Prints Fast

Jabra Speak 510 Holder, 45-Degree Angle Mount

Jabra Speak 510 Holder, 45-Degree Angle Mount, design preview, hero tilt

Design preview. Rendered from the file, not a photo.

The maker says it fits: Jabra Speak 510. See the proof

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

  • Angles your speaker 45 degrees so sound points toward one person, keeping your office mate's workspace quiet
  • Holds your Jabra Speak 510 steady during long conference calls, so you skip headphones and stay comfortable
  • Sits on any desk without sliding, so your speaker stays in place all day
  • Made in the USA and ready to print on demand, so you get a custom fit for your setup

Shared office space means shared sound. This holder angles your Jabra Speak 510 at 45 degrees, so conference audio points toward you instead of bouncing around the room. Your office mate stays focused while you stay in the call.

When two people share one desk, a speaker pointed straight up disturbs everyone nearby. This simple holder solves that. You rotate the speaker to face one person, and the other side gets real quiet. Long conference calls feel less draining without headphones pressing on your ears all day.

The holder props your Jabra at the right angle and keeps it from sliding during calls. Just place it on your desk, add your speaker, and adjust as needed. Done.

1.0k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What it fits

The maker says it fits: Jabra Speak 510

That is the maker's word, not a fit we measured. Check the size below against your own.

Brand names here only say what this part fits. We are not connected to those companies, and they did not make or check this part.

What you get

  • This design prints as one piece.
  • Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.

More like this

Who made this design

Designed by egeltje. We did not draw it.

Shared under BSD. See the original design