Galaxy S7 3D Printed Phone Stand Charging Dock

Your gear, set up the way you pictured it.

5.0k downloads in the maker community

$11.99

Color: Gray

Printed in the USA when you order.

1.You order it
2.We print it fresh
3.It ships to you

Holds your Galaxy S7 upright on your desk so you can see incoming calls and messages without picking it up
Works with your existing Samsung charging cable; just insert it through the bottom slot so charging stays hands-free
Two design options included: Simple model for basic cases, Bulky model for thicker protective cases so your phone fits securely
Tested with four different case types so you know it works with popular Samsung Galaxy S7 cases

Your Galaxy S7 sits right at eye level, charging and ready to use. This 3D-printed dock cradles your phone while your cable plugs in from below, keeping your desk clean and your phone within reach.

Setup takes two minutes. Insert your Samsung charging cable through the opening at the bottom. Slide the cable head into the cut-out, then push it flush into the socket. Your phone now charges upright and stays visible. The dock holds steady on any flat surface, built for phones measuring 142.4 x 69.6 x 7.9 mm with a simple case. If your phone wears a thicker case, use the included Bulky model instead.

This design has been tested with four different case styles, from slim covers to rugged armor cases. You get both model files so you can print the version that matches your setup.

Not affiliated with, endorsed by, or sponsored by Samsung. Samsung and its product names are trademarks of their respective owners.