Skip to content
3D Prints Fast

3D Printed Phone Stand for Laptop

3D Printed Phone Stand for Laptop, design preview, hero tilt

Design preview. Rendered from the file, not a photo.

The maker says it fits: Pixel 6a (phone). See the proof

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

  • Clips to your laptop top so your phone stays put while you work, so you can see messages hands-free
  • You measure your phone and laptop, then customize the mount to fit in minutes
  • Holds your device steady during movement, so your phone won't slide off your lap or desk
  • Designed for Pixel phones with cases, works on any laptop thickness you input

Your phone sits right at your laptop screen, so you see notifications without looking down. This 3D printed mount clips to the top corner of your laptop and keeps your device secure while you work, travel, or move around your space.

The mount grips your phone from above, so it won't budge when your laptop shifts. You customize it by measuring your phone width, length, thickness and your laptop thickness. Enter these numbers into the customizer, and you get a mount built just for your gear. The standard version fits a Pixel 6a phone with case on a 5mm thick laptop.

This design comes from the maker community, from the US. Print it on demand and have it ready to use in days.

3.7k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What it fits

The maker says it fits: Pixel 6a (phone)

That is the maker's word, not a fit we measured. Check the size below against your own.

Brand names here only say what this part fits. We are not connected to those companies, and they did not make or check this part.

What you get

  • This design prints as one piece.
  • Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.

More like this

Who made this design

Designed by zanovis. We did not draw it.

Shared under GNU GPL. See the original design