Blue Yeti Mic Stand Screws and Washers

Your gear, set up the way you pictured it.

2.1k downloads in the maker community

$7.99

Color: Gray

Printed in the USA when you order.

1.You order it
2.We print it fresh
3.It ships to you

Includes test screw, final screw, and two washer styles so you can find the right fit for your setup
Holds your Blue Yeti mic firmly in the stand so it stays put during recording and streaming
Designed from actual measurements and photos, making installation straightforward without guessing
Printed sturdy at 20% infill so screws tighten securely without stripping or damaging threads
Get replacement parts fast, printed on demand from the US so you skip long shipping times

Your Blue Yeti mic sits steady in its stand, ready to record your podcast, stream, or video call. No loose connections. No wobble. Just reliable hardware that works.

These screws and washers replace lost or missing parts on your Blue Yeti stand. The designer measured the original parts and tested everything on a real mic and stand. You get a test screw to check the fit, a final screw with supports for smooth printing, and two washer options with and without a fillet edge. All parts printed at 0.05mm layer height feel sturdy and hold tight when you tighten them down.

Not affiliated with, endorsed by, or sponsored by Prusa. Prusa and its product names are trademarks of their respective owners.