Skip to content
3D Prints Fast

Bicycle Fishing Pole Holder Mount

Bicycle Fishing Pole Holder Mount, design preview, hero tilt

Design preview. Rendered from the file, not a photo.

The maker says it fits: bicycle luggage rack (16mm rail), rear fork. See the proof

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

  • Clamps to your bike's luggage rack so your fishing rod stays secure while you ride to the water.
  • Holds standard 16mm rails, so it fits most bicycle racks without extra adapters.
  • Works on rear forks tilted up to 5 degrees off vertical, giving you mounting flexibility on different bike styles.
  • Printed on demand just for you, so you get a custom part made to your order.

Bring your fishing rod along on your bike ride without wrestling it the whole way. This pole holder mounts right to your luggage rack and grips your rod steady so you can pedal hands-free to your favorite fishing spot.

The holder slides over a 16mm rail, which covers most standard bike racks made in the USA and beyond. If your rear fork leans slightly off vertical, this mount still works; it handles forks angled up to about 5 degrees. Just clamp it down, slide your pole in, and ride.

Each holder is printed on demand for you. That means you get a fresh part built to order, ready to mount and use.

2.4k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What it fits

The maker says it fits: bicycle luggage rack (16mm rail), rear fork

That is the maker's word, not a fit we measured. Check the size below against your own.

Brand names here only say what this part fits. We are not connected to those companies, and they did not make or check this part.

What you get

  • This design prints as one piece.
  • Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.

More like this

Who made this design

Designed by OldFatBastrd. We did not draw it.

Shared under GNU GPL. See the original design