Reflector Lamp Shade for Plants, E27 Fit

Design preview. Rendered from the file, not a photo.

The maker says it fits: E27 light bulb socket. See the proof

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

One side stays open so tall plants get direct light from above
Other side is closed for a reflective coating you add so light aims down at leaves
Shaped to fit an E27 light bulb socket for easy setup near your plants
Simple grid style shade suited for grow lights above indoor greenery
Heat limit: check that your bulb stays well under 100°C before use near the shade

What if your indoor plants got better light without a bulky grow lamp taking over the room? This reflector lamp shade is shaped just for that. One half stays open so taller plants can reach up into direct light. The other half is closed, giving you a surface to line with a reflective material like foil so light bounces back down onto the leaves below.

The shade is shaped to fit an E27 light bulb socket, a common size found in many lamp bases. This makes it easy to add to a lamp you already use for your plant corner or grow shelf. The open and closed halves work together to spread light where your plants need it most.

Keep in mind that some LED bulbs run hot, close to 100°C. Check your bulb's temperature before use so the shade stays clear of direct contact with a hot bulb. This shade is made to order in the USA once you place your order.

What it fits

The maker says it fits: E27 light bulb socket

That is the maker's word, not a fit we measured. Check the size below against your own.

E27 light bulb socket (model E27)From the maker's own listing title, checked 2026-08-13. See the original post

Brand names here only say what this part fits. We are not connected to those companies, and they did not make or check this part.

What you get

This design prints as one piece.
Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PETG. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.

Who made this design

Shared under GNU GPL. See the original design