3D Printed Razor Stand for Double Edge Safety Razors

Design preview. Rendered from the file, not a photo.

The maker says it fits: DE (double-edge) safety razors. See the proof

This model is not currently offered as a verified ready to buy print.

Already have the file?

Upload it and we'll quote your print.

Upload your file

Looking for something like this?

Ask the Solution Counter.

Ask the Solution Counter

What it does

Holds your DE safety razor upright so it dries properly between shaves
Keeps your razor off the counter so your bathroom stays clean and organized
Works with any double edge razor, including vintage and modern models

Your razor deserves a proper home. This stand keeps your double edge safety razor upright and ready, so it dries fully and lasts longer.

The design is simple and sturdy. It holds your razor steady on any bathroom shelf or counter. Whether you use a vintage Gillette or a modern Edwin Jagger, this stand fits them all.

No more tossing your razor in a drawer or letting it sit wet on the sink.

7.5k downloads in the maker community. That is interest in the design on the site it came from, not our sales.

What it fits

The maker says it fits: DE (double-edge) safety razors

That is the maker's word, not a fit we measured. Check the size below against your own.

DE (double-edge) safety razorsFrom the maker's own listing notes, checked 2026-08-13. See the original post

Brand names here only say what this part fits. We are not connected to those companies, and they did not make or check this part.

What you get

This design prints as one piece.
Nothing else to print or buy for this to work.

What it is made of

Designs like this print well in PLA. Compare the materials.

Printed plastic is strong for its size, but it is not metal. We have not load tested this design, so we do not publish a weight rating. Keep it out of a hot car and away from open flame.