Marlin 2.0 Firmware for Anycubic 4MAX Pro

Your printer, running the way it should.

2.2k downloads in the maker community

$8.99

Color: Gray

Printed in the USA when you order.

1.You order it
2.We print it fresh
3.It ships to you

Updated hotend and bed sensors work right out of the box so your printer runs smoothly from day one
TFT screen support included so you can see what your printer is doing without guessing
Filament runout sensor stops printing when you run out so you don't waste time on failed prints
Two versions available: basic setup or with full screen control for the features you need
Tuned PID settings get your nozzle to the right heat so your prints come out clean

Your Anycubic 4MAX Pro works better with the right firmware. This updated Marlin 2.0 package gives you a printer that's ready to print, not ready to frustrate you.

You get two versions to pick from. Choose the basic Marlin 2.0.1 if you want a clean start. Pick the updated version if you want your TFT screen, filament runout sensor, and all the features your printer was made to have. The hotend and bed sensors are set to the correct numbers so everything talks to each other.

Keep in mind: you may need to fine-tune your Z offset and linear advance settings for your specific machine. The filament runout sensor stops your print when you run out, but it doesn't change the filament for you. If you see shifting on the Y axis, you can turn off the S curve in settings.