E3D v6 Fan Duct for Threaded Mount 3D Printed

Your printer, running the way it should.

957 downloads in the maker community

$7.99

Color: Gray

Printed in the USA when you order.

1.You order it
2.We print it fresh
3.It ships to you

Fits threaded heatsink mounts so your fan sits in the right spot without hitting the heater block
Keeps cooling airflow where it needs to be, so your prints come out clean and strong
Works with your E3D v6 hotend setup, so no extra parts or adapters needed
Printed on demand just for you, so you get a fresh part built to order

Your E3D v6 hotend with a threaded mount deserves a fan duct that actually works. Standard ducts bump into your heater block or mounting surface, causing headaches. This custom duct solves that problem by sitting perfectly between the mounting flange and the top of your heater block, with no interference.

You get precise cooling flow right where it counts. The duct design keeps air moving over the heatsink fins without getting in the way of your effector or other parts. Your prints cool down evenly, which means better layer adhesion and fewer defects.

Printed on demand from the US, this duct comes ready to mount. Just install it on your threaded E3D v6 and start printing.