E3D v6 40mm Fan Duct for 3D Printer Hotend

Your printer, running the way it should.

11k downloads in the maker community

$8.99

Color: Gray

Printed in the USA when you order.

1.You order it
2.We print it fresh
3.It ships to you

Fits your E3D v6 hotend the same way as the original so you get better cooling without redesigning your setup
Holds a 40mm case fan instead of a 30mm so your hotend runs cooler and more stable during long prints
Extends 5mm outward to clear obstacles so you avoid jams and keep air flowing freely around your nozzle
Mounts exactly where the stock duct goes so you can swap it in minutes with no modifications needed

Your 3D printer's hotend cools better when you give it room to breathe. This fan duct is built for the E3D v6 and lets you use a bigger, more powerful 40mm case fan so you get steadier temperatures and fewer print failures.

The duct extends down to fit your larger fan and spreads out an extra 5mm to dodge any obstacles near your heatsink. It mounts in the exact same spot as the original E3D fan duct, so swap is quick and clean. You keep the same fan placement on the heatsink fins; the only change is more cooling power working for you.

Get rid of that wimpy 30mm fan and put real airflow where it counts. Your next long print will run smoother.