Cricut Maker Tray Extension Clips

Your printer, running the way it should.

4.1k downloads in the maker community

$28.99

Color: Gray

Printed in the USA when you order.

1.You order it
2.We print it fresh
3.It ships to you

Supports your 12x12 cutting mat so it stays level and secure on the tray
Print as many clips as you need, so you get the exact setup that works for you
Keeps your mat from flopping onto the floor before and after cuts, protecting your work
Uses sticky tack for easy placement without permanent attachment to your machine

Your cutting mat stays put and level. No more mats sliding or dropping to the floor. These tray extensions bump out just enough to hold a standard 12x12 mat in place while you work.

The clips fit snugly around your existing Cricut Maker tray. You print as many as you want, so you can customize the support. Two clips at 15mm wide work great; add a third in the middle if you prefer extra stability. A tiny bit of sticky tack on the inside keeps them from getting bumped around during use.

Note: do not attach these clips permanently if you plan to open the tray compartment, since the clips will block access.