Skip to content
3D Prints Fast
Compatible with Prusa Mendel Inductive Probe Mount, hero tilt

Compatible with Prusa Mendel Inductive Probe Mount

Your printer, running the way it should.

679 downloads in the maker community

$8.99

Color: Gray

Printed in the USA when you order.

  • Made in the USA, printed when you order
  • Secure checkout, safe, encrypted, and trusted
  • Real human support, we are here to help
  1. 1.You order it
  2. 2.We print it fresh
  3. 3.It ships to you
  • Mounts the Fotek PS-05N sensor to your i3 carriage
  • Sits on Greg Frost's Lm8uu carriage with no drilling
  • Lets you run auto bed leveling on a Mendel
  • Saves the time spent twisting bed knobs by hand

Add auto bed leveling to your Prusa Mendel without a fight. This mount holds the Fotek PS-05N inductive proximity sensor on Greg Frost's Lm8uu carriage, so your printer learns the bed instead of asking you to. Stop turning leveling knobs after every print.

The mount sits on the belt gear with the sensor offset 20mm in X and 40mm in Y from the hot end. Wire the sensor into your board, set up the offsets in your firmware, and your first layer goes on smooth.

Note: this mount can shift slightly with bed temperature changes. The original creator now uses an alternate; treat this as a starting point and tune as you go.

Not affiliated with, endorsed by, or sponsored by Prusa. Prusa and its product names are trademarks of their respective owners.

Will it fit? Check the numbers.

Size
20 × 15 × 35 mmfits in your palm
Material
PLA, solid color
Made
In the USA, printed when you order
Works with
Prusa

Sizes come from the real model file, not a guess.

Want a different size? Have your own design?

Upload a file and get a price in seconds. We print it just for you.

Upload your file
$8.99

More like this