Compatible with Prusa 3 Jaw Z Coupling Adjuster

Your printer, running the way it should.

1.3k downloads in the maker community

$8.99

Color: Gray

Printed in the USA when you order.

1.You order it
2.We print it fresh
3.It ships to you

Adjusts your Z axis alignment without drilling into nuts, so your prints come out level and clean
Three jaw design grips your coupling firmly, which means your layers stay consistent across every print
Works with Prusa Mendel frames, so you can upgrade your existing printer without replacing parts
Printed on demand just for you, so you get a fresh part made to spec

Your 3D printer needs a Z axis that stays perfectly aligned so every layer prints flat and true. This three jaw coupling gives you that control without the hassle of drilling dimple holes in a nut and rigging your X axis to hang from them.

The coupling lets you fine tune your Z alignment as needed. The three jaw design holds your coupling steady and secure, which means your prints come out consistent and clean. If you run a Prusa Mendel, this part fits right in and works with your existing frame. You get a printed part made fresh for you, ready to install and use.

Not affiliated with, endorsed by, or sponsored by Prusa. Prusa and its product names are trademarks of their respective owners.