Compatible with Creality Wire Clip for 2020 Profile

Your printer, running the way it should.

12k downloads in the maker community

$9.99

Color: Gray

Printed in the USA when you order.

1.You order it
2.We print it fresh
3.It ships to you

Snaps onto 20 by 20 mm aluminum extrusion frames
Routes wires neatly along the printer frame
Stops cables from snagging the gantry or hot end
Sized to fit Creality CR-10 and similar 2020 frames
Print a handful for the cleanest cable run on your printer

You finish a print and the toolhead cable is sagging across the frame again. These small clips lock onto a 20 by 20 mm aluminum extrusion and route the wires along the frame so the gantry stays clear and the printer looks the way it should.

The clip is sized at one hundred thirty percent of the original BobDavis design so it fits the Creality CR-10 and other 2020 frames without slipping. Snap one on every fifty to one hundred millimeters and you have a clean wire run from the controller to the hot end.

Print a handful, clip them on, and the cable mess is gone in five minutes.

Not affiliated with, endorsed by, or sponsored by Creality. Creality and its product names are trademarks of their respective owners.