ADXL345 Mount for E3D V6 and Dragon Nozzles

Your printer, running the way it should.

$7.99

Color: Gray

Printed in the USA when you order.

1.You order it
2.We print it fresh
3.It ships to you

Slides under the heater block so your cooling ducts fit tight without blocking the way
Works with StealthBurner setups so you get better airflow around your print head
Mounts from below so you can keep your sensor in place while using modern cooling solutions
Needs supports during print so the front bridge comes out clean and strong

Your printer needs an accelerometer mount that fits inside modern cooling systems. This mount slides on from underneath your heater block, so you keep all your cooling ducts in place and nothing gets in the way.

The design sits below instead of in front. That means you use the full cooling power of StealthBurner setups without sacrificing sensor accuracy. The mount holds your ADXL345 steady while your nozzle stays clear for air to flow.

Print this in PETG to give the part a little flex so it handles heat changes well. Add supports everywhere during your print run, especially under the front bridge part. That keeps everything accurate and strong.